SAAB WIS ONLINE

Drivetrain and Front Suspension Frame Insulator Replacement

Drivetrain and Front Suspension Frame Insulator Replacement


Tools Required

CH-45725 Frame Bushing Installer

For equivalent regional tools, refer to Special Tools

Removal Procedure


1. Remove the frame. Refer to Drivetrain and Front Suspension Frame Replacement .


2. Remove cradle bushing with a rubber mallet.


Installation Procedure


1. Install clamp J-45725 onto the bushing leaving about an 1/8 inch from the bottom of the bushing.


2. Align the split of the bushing to the front of the frame.


3. Using J-45725 install the bushing until the entire radius of the bushing is halfway recessed in the cradle.


4. Remove the J-45725 clamp.


5. Install the bushing using the J-45725 until the lip of the bushing is fully seated to the bottom of the cradle assembly.


6. Install the frame. Refer to Drivetrain and Front Suspension Frame Replacement .