Rear Wheelhouse Inner Panel Replacement
|
Rear Wheelhouse Inner Panel Replacement
|
3.
|
Remove all related panels and components.
|
4.
|
Repair as much of the damage as possible to factory specifications. Refer to
Dimensions - Body
.
|
5.
|
Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary.
|
6.
|
Note
|
Do not damage any inner panels or reinforcements. Record the number and location of the original welds for installation of the service part.
|
Locate and drill out all the necessary factory welds (1).
|
7.
|
Remove the rear inner wheelhouse (1).
|
1.
|
Note
|
If the location of the original plug welds cannot be determined or structural weld- thru adhesive was present, space plug weld holes every 40 mm (1 1/2 in) apart.
|
Drill 8 mm (5/16 in) plug weld holes in the service part as necessary in the locations noted from the original panel (1).
|
2.
|
Prepare all mating surfaces as necessary.
|
3.
|
Apply GM-approved Weld-Thru Coating or equivalent to all mating surfaces.
Position the rear inner wheelhouse to the vehicle. Clamp the part in place.
|
4.
|
Plug weld accordingly (1).
|
5.
|
Clean and prepare all welded surfaces.
|
6.
|
Install all of the related panels and components.
|
7.
|
Apply the sealers and anti-corrosion materials to the repair area, as necessary.
|