Ultra High Strength Dual Phase Steel
|
Ultra High Strength Dual Phase Steel
|
This information provides repair recommendations and general guidelines for steel classified as Ultra High Strength Dual Phase Steel (Dual Phase Steel with a tensile strength greater than 800 MPa), also known as DPX.
General Motors recommends the following when repairing or replacing this type of steel during collision repair.
Note
|
•
|
Repair of this type of steel is not recommended.
|
•
|
This type of steel should be replaced at factory joints only. Sectioning or partial replacement is not recommended.
|
•
|
The use of heat to repair damage is not recommended for this type of steel.
|
•
|
Stitch Welding is not recommended for this type of steel.
|
•
|
This classification of steel can not be used as a backing reinforcement or a sleeve for a sectioning joint, unless a specific procedure is available.
|
Recommended Repair:
•
|
Squeeze Resistance Spot Welding can be used to replace factory spot welds, where applicable.
|
•
|
MIG plug welding can be used to replace factory spot welds.
|
•
|
MIG Brazing can be used to replace factory spot welds.
|