Body Panel Paint Protector Replacement (VGC)
|
Body Panel Paint Protector Replacement (VGC)
|
1.
|
The paint protective film and vehicle surface temperature should be 13-32°C (55-90°F) for best results.
|
2.
|
Automatic car washes should be avoided for at least 24 hours after the paint protective film application.
|
3.
|
Wipe the vehicle surface with isopropyl alcohol or flash naptha at the application area.
|
4.
|
Dry the surface with a clean lint-free cloth.
|
5.
|
Create a mixture of 25 percent isopropyl alcohol and 75 percent water and two drops of baby shampoo per 16 oz of fluid mixture.
|
6.
|
Remove the backing liner from the protective film patch.
|
7.
|
Use the solution to liberally spray the adhesive side of the protective patch, the mounting location along with your hands.
|
8.
|
Position the paint protective film patch to the desired location on the vehicle.
|
9.
|
Spray the surface of the film with the alcohol, water and soap solution.
|
10.
|
Using a dampened squeegee remove the air and water solution from under the protective patch. Start at the center of the protective patch and work outward.
|
11.
|
Release any air bubbles with a pin.
|
12.
|
Dry the surface with a clean, lint-free cotton cloth.
|