Rear Compartment Lid Emblem/Nameplate Replacement (xwd Small Letters)
|
|
Rear Compartment Lid Emblem/Nameplate Replacement (xwd Small Letters)
|
|
Callout
|
Component Name
|
Refer to
Exterior Trim Emblem Removal Caution
.
Preliminary Procedures
|
1.
|
The emblem is delivered as a spare part in a package consisting of a frame with a transparent window with protective tape on the back.
|
|
2.
|
Using a heat gun (500-700°F) and with a circular motion, warm the emblem / nameplate to release the adhesive backing from the rear compartment lid.
|
|
3.
|
Use a plastic-type trim tool to remove the old emblem / nameplate from the rear compartment lid.
|
|
4.
|
Using a 50 / 50 mixture by volume of isopropyl alcohol and clean drinkable water, remove any adhesive residue from the rear compartment lid.
|
|
5.
|
Dry the area thoroughly with a clean, dry, lint free towel.
|
|
6.
|
The emblem must be at room temperature (approx. 20°C-68°F) before the emblem can be installed to the rear compartment lid.
|
|
7.
|
Use the following measurements to fit the emblem frame to the rear compartment lid:
|
|
|
•
|
(a) Measure (32.61 mm-1.3 in) from the bottom edge of the endgate and mark a horizontal line using masking tape.
|
|
|
•
|
(b) Measure (24.89 mm-.99 in) from the outer edge of the rear compartment lid and mark the masking tape.
|
|
|
•
|
(c) Measure (16.37 mm-.64 in) from the outer edge of the rear compartment lid and mark the masking tape.
|
|
|
•
|
(d) Measure (54.04 mm-2.1 in) from the outer edge of the rear compartment lid and mark a vertical line using masking tape down to point (b).
|
|
8.
|
Remove the protective tape from the back of the emblem and let the emblem remain in the frame.
|
|
9.
|
Position the frame to the rear compartment lid measurements as described.
|
|
10.
|
Remove the frame from the emblem.
|
|
11.
|
Using the palm of the hand, and a dry clean lint-free towel ensure proper adhesion is made to the rear compartment lid emblem.
|
|
|
1
|
Rear Compartment Lid Emblem / Nameplate (XWD Small)
|
Note
|
|
Remove the masking tape after installation of the emblem / nameplate and clean the surrounding area.
|
|
