SAAB WIS ONLINE

Fuel filter

Fuel filter

Warning

Removal of the fuel filter involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

Work only in a well-ventilated area! If approved equipment for the extraction of fuel vapours is available, be sure to use it.

Wear suitable gloves! Prolonged contact with fuel can cause skin irritation or dermatitis.

Keep a class BE fire extinguisher near at hand! Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.

No smoking anywhere in the vicinity.

Wear protective goggles.


To remove



1. Reduce the fuel pressure by removing the fuel pump fuse no. 19 while the engine is idling. When the engine stops, turn off the ignition and refit the fuse.

2. Remove the fuel filter splash guard.

3. Drain the fuel from the filter before removing it.

4. Undo the banjo fittings on both sides of the filter.


5. Undo the filter clamp.

6. Remove the filter.



To fit

Important

Inspect the sealing washers before fitting and change them as necessary.


Fit in reverse order.

Tightening torques:

Banjo fittings 21 Nm (15.5 lbf ft)