Ignition discharge module
| Ignition discharge module |
| 1. |
Unplug the 10-pin ignition discharge module connector.
|
|
| 2. |
Remove the 4 screws.
|
|
| 3. |
Lift up the module.
|
|
| To fit |
Fit in reverse order.
Spray the connector with Kontakt 61 contact cleaner (part no. 30 21 763).
Coat the rubber seals with Krytox (part No. 30 19 312).
Tightening torque 11 Nm (8.1 lbf ft)
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
