P1310
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Possible misfiring before DTC is generated.
Engine fails to start.
Fuel shut-off
Ignition Discharge Module. Not Powered, Bank 1.
Fault symptoms
|
•
|
Possible misfiring before DTC is generated.
|
Conditions
The following conditions apply for this DTC:
|
•
|
Crankshaft rotating and main relay voltage exceeds 10 V.
|
|
•
|
Voltage on all ignition trigger outputs is below 2 V for 1 second.
|
Diagnostic help
The DTC is generated when the ignition discharge module is not supplied with current.
Check the wiring
|
Note
|
|
Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this.
|
