Aerial amplifier, system 2

Manufacturer:		Fuba.
Type:		Multi-aerial: AM, FM1, FM2 (red).
Location:		Right-hand C-pillar.
Power supply (trigger voltage):		Pin contact / 4.8 x 0.8 mm (male).
Power supply (electrically heated rear window):		Pin contact / 6.4 x 0.8 mm (male).
Aerial signal in, AM/FM2:		Push-button switch, 2-pole (female).
Aerial signal in, FM1/electrically heated rear window:		Pin contact / 6.4 x 0.8 mm (female).
Aerial signal to radio:		HF-switch, Fuba GO-NOGO. (*
Closed-circuit current consumption:	mA	0
Max. current consumption:	mA	< 100 at 13.5 V.

Important
*) Exercise care when disconnecting the HF connector Fuba GO-NOGO. This must be done correctly to avoid damaging the connector. Refer to Antenna amplifier .