SAAB WIS ONLINE

B1795

Symptom: The message “SERVICE ANTI-THEFT ALARM” is shown on SID.

B1795

Tilt sensor, no connection


Fault symptoms

The message “SERVICE ANTI-THEFT ALARM” is shown on SID.

Conditions

Break in the communication to the angle sensor.

Diagnostic help

May be due to a break/short-circuit in the wiring harness.

Main condition

The diagnostic trouble code is generated if a fault is found during two test cycles in succession. A test cycle lasts one second, i.e. it takes two seconds from when the fault occurs until a diagnostic trouble code is generated. If the fault disappears, the trouble code is deleted from the control module memory after the ignition has been turned on 20 times.

Diagnostic trouble codes are not generated if the voltage is below 11 V or over 14 V.

Check wiring harness.

Jiggle the wiring harness at several points and in different directions to reveal intermittent breaks and short-circuits in the leads. Observe the multimeter, test lamp or diagnostic instrument during the test.