SAAB WIS ONLINE

Boot lid wiring harness

Boot lid wiring harness


To remove

Note

If the car is equipped with a radio other than a genuine Saab radio, check that the customer has the radio code before commencing work.

Disconnect the negative battery cable.



1. Remove the boot lid trim .

2. Remove the luggage compartment sill protection .

3. Detach the LH rear edge of the luggage compartment trim and carefully fold it out.

4. Unplug the wiring harness connector from the car wiring harness.

5. Detach the grommet from the car and thread the harness out through the rear wing.

6. Detach the wiring harness from the boot lid hinge.

7. Detach the grommet from the boot lid, use 82 93 474 removal tool and prise out carefully.

8. Carefully mark all connectors before disconnecting them from their components.

9. Undo the wiring harness from the boot lid and carefully thread it out through the hole.


To fit


1. Thread the wiring harness into the boot lid and push the grommet into place.

2. Lay out the new wiring harness the same as the old one and secure it in the same way. Make sure all grommets seal tightly.

3. Plug in the connectors to their respective components. If in doubt refer to wiring diagrams/component lists for the respective system.

4. Thread the wiring harness through the rear wing and fit the grommet.

5. Attach the wiring harness to the boot lid hinge.

6. Plug in the connector to the car wiring harness and fasten with a cable tie.

7. Fit the luggage compartment trim.

8. Fit the luggage compartment sill protection .

9. Fit the boot lid trim .

10. Connect the negative battery cable. Set the clock and program the radio code where applicable.


Important

Secure the wiring harness to prevent the risk of chafing and rattling.

Check all rubber seals to minimize the risk of leakage.


Note

Spray all the connectors with “Kontakt 61” to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline.