Wiring harness, passenger door
|
|
Wiring harness, passenger door
|
|
Note
|
|
If the car is equipped with a radio other than a Saab original radio, check that the customer has the radio code before commencing work.
|
|
Disconnect the negative battery cable.
|
|
1.
|
Remove the door trim, see
|
|
2.
|
Unplug the connector between the door and the rear harness.
|
|
3.
|
Detach the connector from the door.
|
|
4.
|
Mark all the connectors accurately
before unplugging them from their respective components.
|
|
5.
|
Carefully remove the wiring harness without damaging cable ties, etc., that are to be refitted.
|
|
6.
|
Lay out the new wiring harness the same as the old one and secure it in the same way. Make sure all grommets are sealing tight.
|
|
7.
|
Plug in the connectors to their respective components. If in doubt refer to wiring diagrams/component lists for the respective system.
|
|
8.
|
Attach the connector to the door and plug in the rear harness connector.
|
|
9.
|
Refit the door trim, see
|
|
10.
|
Connect the negative battery cable. Set the clock and program the radio code where applicable.
|
|
Important
|
|
Secure the wiring harness to prevent the risk of chafing and rattling.
|
|
Check all rubber seals to minimize the risk of leakage.
|
|
|
|
Note
|
|
Spray all the connectors with “Kontakt 61” to prevent copper rust from forming. Clean all the grounding points and apply them with Vaseline.
|
