SAAB WIS ONLINE

Intermediate shaft, 4-cyl.

Intermediate shaft, 4-cyl.

To remove


1. Cover the wings and lift off the battery cover.


2. Remove the negative lead from the battery.

3. Raise the car.

4. Remove the RH wheel.

5. Remove the cover on the belt circuit.


6. Remove the upper engine cover.

7. Remove the clamp for the steering servo pipe.

8. Place a wedge between the oil sump and subframe.

9. Relieve the tension on the belt tensioner with 83 95 254 Drawbar handle, hydraulic belt tensioner and lift off the multigroove belt.


10. Remove the belt tensioner using an 8 mm allen key.

11. Remove the upper generator bolt with an 8 mm allen key

12. Undo the clips for the brake hose and bend the hose to one side. Detach the ABS cable

13. Remove the outer suspension arm through bolt from the steering swivel member.


14. Tap the drive shaft off the intermediate shaft with a brass drift and hammer.

15. Prise loose and lower the suspension arm and secure it in this position with a block of wood between the suspension arm and the anti-roll bar.

16. Turn the wheel to the left for better access to the drive shaft. Tap the drive shaft further out if necessary. Grip the MacPherson strut and pull. The drive shaft will follow. Then lower it down in front of the suspension arm.

17. Remove the generator cables and the lower generator bracket bolt.


18. Move the generator out of the way.

19. Unscrew the support bearing bracket screws.


Important

Place a vessel under the gearbox to avoid oil spill on the floor.


20. Fold out the support bearing bracket from the guide pins in the engine block and extract the intermediate shaft from the gearbox.


To fit


1. Fit 83 95 162 Protective collar, drive shafts into the sealing ring.


Important

Always change the shaft seal in the gearbox. Lubricate with transmission fluid, see


2. Make sure that the intermediate shaft is clean and then align the intermediate shaft in the tool.

Important

Fit the intermediate shaft in the gearbox until about 20 mm remains and extract the tool before the shaft's sealing surface reaches the shaft seal.


3. Push in the rest of the shaft.

4. Guide the support bearing bracket onto the upper locating pin and then tighten the bearing bracket.

5. Make sure that the adjuster sleeves in the generator bracket is tapped out approx. 1 mm to facilitate fitting. Then fit the two generator retaining bolts and tighten the lower one.


6. Connect the generator cables.

7. Tilt out the MacPherson strut and attach the drive shaft to the intermediate shaft until the circlip snaps in place. Lubricate the splines with universal paste 87 81 684, see Summary of lubricants and sealants


8. Remove the wedge, raise the suspension arm and connect the steering swivel member. Fit and tighten the bolt.

Tightening torque 100 Nm (74 lbf ft)

Warning

Make sure the steering link pin is visible on top of the steering swivel member before fitting the bolt.


9. Secure the brake hose to the mounting on the steering swivel member and fit the clips. Fit the ABS cable (2 mountings).

10. Fit the upper engine mounting.

11. Fit the clamp for the steering servo pipe.

12. Tighten the upper bolt on the generator.


13. Fit the belt tensioner.

14. Fit the pulley.

15. Fit the cover for the belt circuit.


16. Fit the wheel.

Tightening torque 110 Nm (80 lbf ft)

Important

The wheel must be suspended freely when tightening the wheel bolts


17. Lower the car to the floor.

18. Fit the upper engine cover.


19. Connect the negative lead to the battery and fit the battery cover.

20. Fill up with automatic transmission fluid to the correct level.

21. Set the clock and radio code if applicable.