SAAB WIS ONLINE

Gear lever housing

Gear lever housing

To remove



1. Remove the centre console as described in group 8 "Body, Interior equipment".

2. Engage 4th gear and secure 4th in the gearbox with 87 92 335 Locking pin .

3. Undo the pinch-bolt clamp to the selector rod universal joint.

4. Remove the bolts securing the gear lever housing.


5. Lift the gear lever housing and unplug the electrical connection to the ignition switch.

6. Lift out the gear lever housing.


To fit



1. Insert the end of the selector rod through the rubber gaiter. Put the gear lever housing in place in the car.

2. Plug in the electrical connection to the ignition switch and fit the cable entry into the gear lever housing.

3. Fit the air duct before bolting down the gear lever housing.

4. Tighten the gear lever housing (4 bolts). Note that there are 2 guide pins on the gear lever housing.

Tightening torque 8 Nm (6 lbf ft)

5. Engage 4th gear and insert 87 92 632 Locking pin into the gear lever housing.

6. Tighten the pinch-bolt clamp at the gear linkage in the engine bay.


Tightening torque 22 Nm (16 lbf ft)

7. Remove the locking pin from the gearbox and gear lever housing.

8. Check that all gears can be engaged and that the key can be removed in reverse.

9. Fit the centre console .