Wheel sensor, front left
| Wheel sensor, front left |
| 1. |
Unplug the connector.
|
|
| 2. |
Raise the car and remove the wheel.
|
|
| 3. |
Clean the area round the wheel sensor using a soft wire brush.
|
|
| 4. |
Undo the wheel sensor retaining bolt and remove the wheel sensor.
|
|
| 5. |
Remove the grommet and withdraw the lead.
|
|
| 6. |
Detach the lead from the clips and lift out the sensor.
|
|
| To fit |
| 1. |
Fit the wheel sensor in its holder and tighten the retaining bolt.
|
|
| 2. |
Insert the lead.
|
|
| 3. |
Push the lead into the clips and fit the grommet.
|
|
| 4. |
Fit the wheel, see
Wheels
, and lower the car.
Tightening torques aluminium wheel 110 Nm (81 lbf ft) steel wheel 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft) |
|
| 5. |
Plug in the connector.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
