C2415, C2450 , C2455 , C2485, C0141 , C0146 , C0151 , C0156
Read the instructions below then start the fault diagnostic procedure.
Symptom: Warning lamps for ABS and brakes are on as also is the central warning lamp. TCS OFF warning lamp is on. No ABS or TCS function.
| C2415, C2450 , C2455 , C2485, C0141 , C0146 , C0151 , C0156 |
C2415 Solenoid Valves Rear Left. Incorrect
C2450 Solenoid Valves Front Left. Incorrect
C2455 Solenoid Valves Front Right. Incorrect
C2485 Solenoid Valves Rear Right. Incorrect
C0141 Pressure Increase Valve 1. Incorrect.
C0146 Pressure Relief Valve 1. Incorrect.
C0151 Pressure Increase Valve 2. Incorrect.
C0156 Pressure Relief Valve 2. Incorrect
Fault symptoms
Warning lamps for ABS and brakes are on as also is the central warning lamp.TCS OFF warning lamp is on.
No ABS or TCS function.
Conditions
The valves are monitored continuously for circuit continuity and short-circuiting.The valve test starts when the ignition is ON and road speed is above 6 km/h.
Diagnostic help
The solenoid valves can be activated using the diagnostic tool.| - |
Select “Activate”
|
|
| - |
Select “Valves”
|
|
Select the valve from the submenu. The selected valve will be activated at a frequency of 1 Hz for about 30 seconds.
Change the control module. Refer to Before changing a control module
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
