SAAB WIS ONLINE

Electronic Brake-force Distribution (EBD)

Electronic Brake-force Distribution (EBD)

The EBD function is integrated in the control module and can be compared to a load-sensing valve for the rear-wheel brakes. For optimum braking, the maximum braking force must be applied to both the front and rear wheels under all conditions and loads.



The EBD function comes into play earlier than the normal ABS mode and this gives a more comfortable ride for the car occupants.

For good directional stability, the rear wheels must not be allowed to lock-up before the front ones. Because it takes a greater braking force to lock the wheels on a heavily loaded car, for instance, the control module monitors wheel speed and, via the inlet valves, modulates brake pressure to the rear wheels to ensure that the relative slip between the front and rear wheels does not exceed 3 km/h.

The EBD function will not become operative unless the following criteria are met:


• The road speed of the car is greater than 50 km/h.

• The control module receives a signal from the brake lights switch indicating that the brakes have been applied.

• The retardation force is greater than 0.25 G.

• The relative slip between the front and rear wheels is greater than 3 km/h.

When these criteria have been met, both the rear-wheel inlet valves close and the EBD function is activated to keep the relative slip between front and rear wheels below 3 km/h.

If any wheel tends to lock during EBD modulation, the control mode switches to normal ABS modulation.