Indicator lamp TCS OFF
| Indicator lamp TCS OFF |
Should any fault arise in the TC/ABS system, the control module grounds pin 20 and indicator lamp TCS OFF comes on. The warning lamp also comes on when the system is disengaged manually, which can be done at speeds below 60 km/h by pressing in the TCS button. The system can be engaged by pressing in the TCS switch at any desired speed, when the TCS OFF lamp will go out again.
The lamp lights up when the ignition is switched on. If no fault is detected it goes out after 3-5 seconds.
in the event of a system fault which affects the ABS function, pin 21 will also be grounded. This causes the warning lamps for ABS and brakes to light up as well as the central warning lamp.
Diagnostics
The 31-pin connector has a short-circuiting jumper that grounds pins 20 and 21 when the connector has been unplugged from the control module. This will turn on the ABS, brake fluid and central warning lamps together with the TCS OFF indicator.No diagnostic trouble code will be set if the warning lamp is faulty.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
