Fitting the weatherstrip in the steering wheel
|
|
Fitting the weatherstrip in the steering wheel
|
Warning
|
|
Read the safety and handling instructions for the Airbag (SRS) before starting work.
|
|
|
|
|
|
|
1.
|
Turn the ignition key to the OFF position and remove it.
|
|
2.
|
Remove the airbag module, two plugs and two screws.
|
|
3.
|
Lift out the module and unplug the cable connections.
|
|
4.
|
Clean the surface from grease and dirt. Use
93 160 920 Cleaner
.
Fit the weatherstrip even with the interior edge as illustrated. Press in the weatherstrip securely.
|
Note
|
|
It is important that the weatherstrip sits tightly against the steering wheel cover so that air does not leak out.
|
|
|
5.
|
Plug in the cables to the airbag module.
|
|
6.
|
Fit the module and its two screws. Make sure the strip does not poke out of the edges. Fit the plugs in the screw holes.
|
|
7.
|
Start the engine and check that the airbag lamp does not indicate a fault.
|
|
|
•
|
If the lamp indicates a fault, the airbag system performs a fault diagnosis.
|
|
8.
|
Check the signal function.
|
