Side airbag, up to and including VIN W3088396 (US X3005843)
|
Side airbag, up to and including VIN W3088396 (US X3005843)
|
1.
|
Ignition switch in the OFF position.
|
2.
|
Slide the seat forwards as far as it will go
|
3.
|
Unscrew the seat at the rear, 2 screws.
|
4.
|
Slide the seat rearwards and undo the 2 screws at the front.
|
5.
|
Tilt the seat rearwards, cut the cable tie and unplug the 29-pin connector under the seat.
|
6.
|
Remove the covers from the seat rail.
|
7.
|
Lift the seat out of the car.
|
8.
|
Detach the lower edge of the backrest upholstery fabric.
|
9.
|
Remove the upholstery retaining strip at the bottom.
|
10.
|
Snip the staples securing the board to the upholstery fabric. Withdraw the sheet of cardboard.
|
11.
|
Detach the rear section of the backrest upholstery fabric by removing the upholstery retaining strip along the sides and folding the fabric out of the way.
|
12.
|
Remove the upholstery retaining strip along the edge at the rear of the backrest frame.
|
13.
|
Unplug the side airbag's connector.
|
14.
|
Remove the side airbag, 3 nuts.
|
15.
|
Lift out the side airbag.
|
Fit in reverse order.
Check the SRS system and control module with the diagnostic tool as follows:
With the ignition in the ON position, connect the diagnostic tool to the diagnostic socket under the dashboard. Delete any trouble codes.
Switch off the ignition and switch it on again. Wait at least 10 minutes with the ignition switched on.
Check whether a diagnostic trouble code (DTC) is displayed:
If a diagnostic trouble code is displayed:
Carry out fault diagnosis in accordance with the directions given for each DTC.
If no diagnostic trouble code is displayed:
Fitting completed correctly. Disconnect the diagnostic tool.