Rear nut piece, front subframe
|
|
Rear nut piece, front subframe
|
|
1.
|
Remove the carpeting to expose the floor.
|
|
2.
|
Measure 160 mm inwards from the corner of the pressing and 25 mm above it.
|
|
3.
|
Scrape off the insulating mat until the marking in the sheet metal is visible.
|
|
4.
|
If necessary, remove the bolt from underneath.
|
|
5.
|
Use a 35 mm hole saw to cut out a hole in the marking.
|
|
6.
|
Use a screwdriver to snap out the old nut piece from the holder. Use a pair of pliers or a piece of bent wire to lift out the nut piece.
|
|
1.
|
Fit a new nut piece without plastic holder.
|
|
2.
|
Fit the bolt from underneath.
|
|
3.
|
Apply anti-corrosive agent to the edge and fit a plug, part No. 43 33 498.
|
|
4.
|
Remove all swarf, drillings and grinding dust from the floor, using a vacuum cleaner.
|
|
5.
|
Fit a new insulating mat.
|
