SAAB WIS ONLINE

Compressor high-pressure pipe (V6)

Compressor high-pressure pipe (V6)

To remove



1. Place the car on a lift.

2. Drain the refrigerant from the A/C system, see .

3. Detach the high-pressure hose from the compressor and plug the openings.

4. Detach the pipe from the receiver and plug the openings.


5. Loosen the pipe from the holder on the subframe and remove it.


To fit


Note

Insert the high-pressure pipe in the engine compartment from the left side.



1. Position the high-pressure hose in the engine compartment.

2. Remove the plugs and lubricate the O-ring on the connection to the receiver.

3. Screw on the PAD connection to the receiver.

Tightening torque: 8 Nm (5.9 lbf ft)

4. Remove the plugs and lubricate the O-ring on the compressor connection.

5. Adjust the oil volume in the compressor, see .


Press on the PAD connection to the compressor and tighten.

Tightening torque: 20 Nm (14.8 lbf ft)

6. Press in the high-pressure pipe to the holder on the subframe.

7. Vacuum pump the A/C system and refill with refrigerant, see .