SAAB WIS ONLINE

Evaporator temperature sensor

Evaporator temperature sensor

To remove



1. Remove the glove box. See group 8, Interior equipment , ”Adjustment and replacement”.

Remove the trim from the side of the centre console.

2. Cut the cable tie holding the wire harness to the service cover. Also cut the cable tie holding the cooler hose to the glove box.


Remove the service cover.

3. Remove the fresh-air filter.

4. Put a hand into the filter holder and carefully pull out the temperature sensor from the evaporator.


5. Separate the connector and detach contact from the plate.

Lift up the plate and unplug the contact.


To fit



1. Locate the temperature sensor in the old hole in the evaporator.

Place the lead's grommet in the groove by the upper fin.

2. Fit the fresh-air filter. See also Replacing the fresh-air filter (combifilter) regarding filter replacement.


3. Fit the temperature sensor connector from the back of the plate. Plug in the contact from the car's wiring harness.

4. Fit the service cover.

Fasten the wiring harness and cooler hose with cable ties. To ensure tightness, check that the lead's rubber grommet is located correctly.

5. Replace the side trim on the centre console.


Fit the glove box. See group 8, Interior equipment ,”Adjustment and replacement”.