Front Seat
Front Seat |
|
To remove |
1. |
Slide the seat to the forward position.
Emergency operation of electrically adjustable seat: If the seat cannot be operated in a fore and aft direction, emergency operation must be used so that it can be removed. |
2. |
Undo the rear of the seat, 2 bolts.
|
3. |
Slide the seat backwards and undo the front 2 bolts.
|
4. |
Tilt the seat back, snip the cable tie and unplug the 29-pin connector under the seat.
|
5. |
Lift out the seat and if necessary release the belt from the seat.
Retain the covers under the seat rails. |
To fit |
1. |
Lift the seat into place. Plug in the 29-pin connector under the seat
Fit a new cable tie. Fit the belt to the seat if it has been removed. |
2. |
Slide the rails into the front keys.
|
3. |
Fit the front bolts and run the seat forwards. If emergency operation has been used, the
bevel gear must be fitted
.
|
4. |
Fit the covers and position the rear screws.
|
5. |
Make sure the catches on the right-hand and left-hand sides have engaged.
|
6. |
Tighten the rear screws with a torque wrench.
Tightening torque: 24 Nm (18 lbf ft) |
7. |
Move the seat backwards and make sure the catches on the right-hand and left-hand sides have engaged.
|
8. |
Tighten the front screws with a torque wrench
Tightening torque: 24 Nm (18 lbf ft) |