Rear silencer
Rear silencer |
To remove |
1. |
Raise the car.
|
2. |
Mark the underside of the exhaust pipe 95 mm from the joint where it is welded to the rear silencer.
|
3. |
Cut the exhaust pipe at right angles.
|
4. |
Remove the silencer.
|
5. |
Clean the cut to remove burrs and dirt.
|
To fit |
1. |
Fit the new silencer and adjust it so that it hangs straight.
|
2. |
Check that the end pipe lies in the centre of the cut-out in the bumper and matches the bumper profile.
|
3. |
Tighten the nuts on the clamps.
Tightening torque: 70 Nm (51.6 lbf ft). |