P0502
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE.
Cruise control not working.
Low engine torque on cars with manual gearbox.
Vehicle Speed. No input signal.
Fault symptoms
|
•
|
Cruise control not working.
|
|
•
|
Low engine torque on cars with manual gearbox.
|
On-Board Diagnostics
Type of diagnosis:
|
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
|
-
|
Engine running. Engine speed over 2000 rpm. Load over 500 mg/c. Brake pedal not depressed.
|
Fault criteria:
|
-
|
No vehicle speed for more than 5 s.
Then, 17 minutes without the vehicle speed leaving 0. On automatic cars, the selector lever must also have another value than P or N. Enable criteria for these two fault criteria need not be fulfilled.
|
Dependents
:
System reaction to a fault:
|
-
|
Cruise control blocked. Vehicle speed (Bus from MIU) used as substitute value.
|
OK report:
|
-
|
60 s has expired since start. Vehicle speed has exceeded 0 on some occasion.
|
Fault handling:
(See “Fault diagnosis, general” for more information.)
Diagnostic help
Fault diagnosis concerns an electrical fault in the connecting leads. (Check first whether the fault is located in ABS or TC/ABS.)
Functions in the diagnostic tool related to the fault:
|
•
|
Diagnostic status for the diagnosis.
|
|
•
|
Vehicle speed (Wire from ABS or TC/ABS.), unit km/h.
|
See also the description of readings in ”Fault diagnosis, general” for more information.
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.
See
.
