Ignition discharge module
| Ignition discharge module |
| 1. |
Unplug the 10-pin ignition discharge module connector.
|
|
| 2. |
Remove the 4 screws.
|
|
| 3. |
Lift up the module.
|
|
| To fit |
Fit in reverse order.
Spray the connector with Kontakt 61 contact cleaner (part no. 30 21 763).
Coat the rubber seals with Krytox (part No. 30 19 312).
Tightening torque: 11 Nm (8.1 lbf ft)
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
