SAAB WIS ONLINE

P1923

Read the instructions below then start the fault diagnostic procedure.

Symptom: Some of the following symptoms may perhaps be observed: Diagnostic trouble code P1921 or P1902 in TCM (if the TCM can be contacted). Additional diagnostic trouble codes in the Trionic (P1901, P1902 or P1908). Engine fails to start. Automatic transmission in limp-home mode. CHECK GEARBOX

P1923


No Bus Data From TCM. See Fault Tracing 3:5 Bus and Diagnostic Communication.


Fault symptoms

Some of the following symptoms may perhaps be observed:


Diagnostic trouble code P1921 or P1902 in TCM (if the TCM can be contacted).

Additional diagnostic trouble codes in the Trionic (P1901, P1902 or P1908).

Engine fails to start.

Automatic transmission in limp-home mode.

CHECK GEARBOX


Conditions

The following conditions apply for this DTC:


The TCM has been present on the bus at some time previously.

Engine running and no communication for more than 3 seconds.


Diagnostic help

Fault diagnosis concerns intermittent electrical faults in the power supply for the sending control module or in a bus lead.

Check the wiring

Note

Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this.