LED (Light Emitting Diode)
| LED (Light Emitting Diode) |
| General |
As a check for the theft alarm, an LED is mounted in the centre of the dashboard. The LED flashes at varying frequency or lights continuously depending on the different conditions. The table overleaf shows some normal cases.
| Function |
The LED is powered by +30 from fuse 9 (22a) and is grounded via pin 27 on TWICE. TWICE controls the ground connection and therefore also the activation of the LED and its flash frequency.
| Self diagnosis |
Whenever the alarm is armed, a self-diagnosis is carried out during the delay time (10 seconds) while the LED is lit continuously. If a fault is found, a diagnostic trouble code is stored in the control module and the LED does not flash. The other functions of the alarm are not affected.
|
Function
|
LED (Light Emitting Diode)
|
Time
|
Flash frequency
|
|
Arming
|
Lit continuously
|
10 sec (delay period)
|
|
|
Alarm, armed
|
Flashing
|
Time
|
1 flash/3 sec
|
|
Door, boot lid/tailgate or bonnet is open while arming
|
Flashing
|
10 secs.
|
1 flash/sec
|
|
Door, boot lid/tailgate or bonnet is opened during the delay
|
Lit continuously - flashing
|
10 secs.
|
1 flash/sec
|
|
Door, boot lid/tailgate or bonnet is closed during the delay
|
Flashing - lit continuously
|
10 secs.
|
|
|
Boot lid/tailgate is closed after the delay
|
Flashing - lit continuously
|
10 secs.
|
|
|
Boot lid/tailgate is opened after the delay
|
Flashing
|
|
|
|
Self-arming, theft alarm
|
Flashing
|
10 secs.
|
Double flash/3 sec
|
|
Immobilization
|
Flashing
|
|
|
|
Disarmed alarm
|
Lit continuously
|
2 secs.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
