Input shaft speed sensor
Input shaft speed sensor |
1. |
Remove the battery cover, battery and battery tray.
|
2. |
Disconnect the battery cable.
|
3. |
Clean the area round the sensor. Remove the sensor's retaining bolt.
|
4. |
Raise the car.
|
5. |
Remove the left-hand front wheel.
|
6. |
Gently work the sensor out of its location.
|
7. |
Unplug the connector.
|
Fitting |
1. |
Connect the sensor.
|
2. |
Fit the sensor in place.
|
3. |
Fit the front wheel.
Tightening torque: 120 Nm (89 lbf ft) |
4. |
Lower the car to the floor.
|
5. |
Tighten the sensor's retaining bolt.
Tightening torque: 6 Nm (4.5 lbf ft) |
6. |
Refit the battery tray, battery and battery cover.
|
7. |
Set the right time on the clock.
|