Wheel sensor, rear (VIN: X3025752-)
Wheel sensor, rear (VIN: X3025752-) |
To remove |
1. |
Raise the car and remove the wheel.
|
2. |
Press back the brake piston with slip-joint pliers.
|
3. |
Remove the brake caliper and suspend it.
|
4. |
Back off the handbrake adjuster. It is accessible through a hole in the brake disc.
|
5. |
Remove the brake disc retaining bolt. Remove the brake disc.
|
6. |
Remove the air separator.
|
7. |
Remove the bolt securing the handbrake cable mounting.
|
8. |
Unplug the connector from the wheel sensor.
|
9. |
Detach the wheel sensor cable from the holder.
|
10. |
Remove the mounting for the wheel sensor cable and brake pipe (2 nuts).
|
11. |
Remove the wheel hub nuts. Use a long 15mm socket with 3/8 drive, part no. 30 34 444 and extension with ball fitting.
|
12. |
Remove the wheel hub from the disc back-plate. Let the disc back-plate and handbrake unit hang from the cable.
|
To fit |
1. |
Clean the contact surfaces using a wire brush.
|
2. |
Fit the wheel hub on the back-plate and secure them to the longitudinal link using new nuts. Tighten the nuts alternately.
Tightening torque: 50 Nm +30° (40 lbf ft +30°). |
3. |
Fit the brake disc.
Fit the lock screw with Loctite 242. Tightening torque: 10 Nm (7 lbf ft). |
4. |
Adjust the handbrake, see
Adjusting handbrake shoes
.
|
5. |
Fit the brake caliper. Use 74 96 268 Loctite 242 on the bolts.
Tightening torque: 80 Nm (59 lbf ft). |
6. |
Fit the mounting for the wheel sensor cable and brake pipe.
Tightening torque: 24 Nm (18 lbf ft). |
7. |
Fit the wheel sensor cable to the mounting.
|
8. |
Plug in the connector to the wheel sensor.
|
9. |
Fit the mounting for the handbrake cable.
Tightening torque: 8 Nm (6 lbf ft). |
10. |
Fit the air separator.
|
11. |
Fit the wheel. See
Wheels
.
Tightening torques aluminium rim 110 Nm (81 lbf ft) pressed steel rim 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft) |
12. |
Lower the car to the floor.
|
13. |
Depress the brake pedal to press out the pistons in the brake calipers.
|