(731-2472) Change to a new type of suspension arm
|
TECHNICAL SERVICE BULLETIN
|
|
Bulletin Nbr:
|
731-2472
|
|
Date:
...........
|
Juni 2004
|
|
Market:
|
all
|
|
|
Change to a new type of suspension arm
|
Saab 9-5 M98-M01
Suspension arms fitting the above cars have been discontinued and are replaced by suspension arms developed for M02-. The holes for fitting the ball joint in the suspension arm are larger on the new suspension arm which is why a solution in accordance with the following must be implemented if a new suspension arm is to be fitted to an older car.
|
1.
|
Remove the suspension arm in accordance with WIS - 9-5 Steering assembly - Steering linkage - Adjustment/Replacement - Suspension arm.
|
|
2.
|
Fit a new rear bush with nut, adapted for the new suspension arm.
Tightening torque 105 Nm (77 lbf ft)
|
|
3.
|
Drill out the three holes on the ball joint with a 10.4 mm (US SAE 13/32") bit.
|
|
4.
|
Use new bolts, washers and nuts designed for the new suspension arm and fit the ball joint on the suspension arm.
Tightening torque 60 Nm + 30° (49 lbf ft + 30°)
|
|
5.
|
Continue with WIS - 9-5 Steering assembly - Steering linkage - Adjustment/Replacement - Suspension arm, step 3 - under "To fit".
|
|
Warranty/Time Information
|
