Boot lid hinges, 4D
Boot lid hinges, 4D |
1. |
Protect the rear wing with a cover and then place a support under the boot lid.
|
2. |
Remove the clip securing the upper gas spring mounting and remove the gas spring from its mounting.
|
3. |
Remove the two nuts on the boot lid.
|
4. |
Detach the grommet hose from the hinge.
|
5. |
Remove the screws securing the hinge to the body
|
6. |
Lift off the hinge.
|
To fit |
1. |
Seal the gap between the boot lid hinge mounting and the body by the front bolt (see illustration).
Apply finishing paint. Position the hinge correctly. |
2. |
Screw on the hinge to the body.
|
3. |
Fasten the grommet hose to the hinge.
|
4. |
Screw on the nuts on the boot lid.
|
5. |
Fit the gas spring.
|
6. |
Remove the support and protective cover.
|
7. |
Check the fit of the boot lid and adjust as necessary.
|