Tailgate lock cylinder, 5D
|
|
Tailgate lock cylinder, 5D
|
|
2.
|
Remove the frame around the inner door handle by prising with a screwdriver in the three recesses. Once the frame clips have been released, pull the frame down and bend it out.
|
|
3.
|
Remove the inner tailgate trim by removing the door pull retaining screws and the plastic clips in the trim.
|
|
4.
|
Lift off the tailgate trim as described below:
|
|
|
4.a.
|
Pull down the top of the trim to release it from the clips.
|
|
|
4.b.
|
Pull back on the trim to release the guide pin, taking care not to break it.
|
|
5.
|
Unscrew the nuts and unhook the lock rod from the driver.
|
|
6.
|
Remove the lock cylinder. Unplug the connector.
|
|
1.
|
Check the seal, fit the cylinder and tighten the nuts. Plug in the connector.
|
|
2.
|
Hook on the lock rods to the driver.
|
|
3.
|
Fit the inner trim by inserting the guide pin at the door pull and fastening with the clips at the edge of the window. Screw in the two door pull screws. Fasten the remaining clips around the trim.
|
|
4.
|
Fit the frame around the inner door handle.
|
