SAAB WIS ONLINE

Rear bumper, 5D

Rear bumper, 5D

To remove



1. Undo the screws in the wheel housing, 2 on each side.

2. Open the tailgate

3. Remove the covers from the storage compartments on right and left sides and remove the storage compartments.


4. Remove the insulating pads.

5. Undo the nuts securing the bumper. The lower bolts have nuts only if the car is equipped with a towbar attachment.


6. Together with an assistant, pull out the bumper from the edges of the wheel housings and lift the bumper backwards.

Important

Be careful to avoid damaging the paintwork.



To fit



1. Place the bumper in position and press it over the edges of the wheel housings. Make sure it is in the correct position along the guides in the rear wings.

2. Screw on the nuts by hand.

3. Position the bumper correctly and tighten the screws in the edges of the wheel housings.


4. Tighten the retaining nuts.

5. Refit the insulating pads.


6. Refit the storage compartments.

7. Close the tailgate and check the fit of the bumper against the tailgate.