Replacement of rear upper protective shell 5D
| Replacement of rear upper protective shell 5D |
| 1. |
Position the car on a lift and raise it.
|
|
| 2. |
Undo the screws securing the upper protective shell.
|
|
| 3. |
Lower the car to the floor.
|
|
| 4. |
Lift the protective shell out of the clips. Bend the shell to the rear and lift it off.
|
|
| To fit |
| 1. |
Fit the protective shell by snapping it into the clips and guiding the tabs to the screws.
|
|
| 2. |
Raise the car.
|
|
| 3. |
Tighten the screws.
|
|
| 4. |
Lower the car and check the fit.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
