The side windows falter when drawn up and down
Symptom: The side windows can sometimes falter when raising and lowering.
|
The side windows falter when drawn up and down
|
Fault symptoms
The side windows can sometimes falter when raising and lowering.
Probable cause
The pop-rivets inside the window moulding protrude too much and the friction between moulding and glass is too great. Additionally the window attachment may need adjustment.
1.
|
Clean off any paint protector on the glass.
|
2.
|
Lower the side window, insert a blunt object into the weatherstrip and see if any of the pop-rivets are protruding.
If the rivets are correctly fitted, continue with step 9.
If any of the rivets are protruding, continue with step 3.
Note
|
Do
not
use a pointed or sharp object.
|
|
3.
|
Detach the front or rear end of the window moulding.
|
4.
|
Inspect the two pop-rivets (part no. 79 72 516) at the front edge of the moulding.
|
5.
|
Inspect the three pop-rivets (part no. 46 85 632) at the rear edge of the moulding (B-pillar).
|
6.
|
Check the pop-rivet (part no. 79 72 516) in the rear lower edge
|
7.
|
Drill out the faulty pop-rivets and fit replacements.
|
8.
|
Clean the moulding of drilling filings and refit it.
Note
|
Check the rivets one more time before fitting the moulding.
|
|
9.
|
Spray the moulding
inside
with Krytox 30 32 497. Use the extension pipe on the spray bottle.
|
10.
|
Dry away excess spray from the mouldings. Raise and lower the window five times to distribute the lubricant.
|
11.
|
Check the function.
If the problem remains, continue with step 12
If the function is correct, clean the window.
|
12.
|
Check the adjustment of the window by lowering it 10 mm and gripping the upper edge. If it does not move 1-3 mm forward and back it must be adjusted as per the following steps:
|
13.
|
Remove the door trim and water cover.
|
14.
|
Undo the two screws on the rear rail. Grip the top of the window and pull it back towards the B-pillar. Pull down the rail until 1±0,5 mm of the oval hole is visible. Tighten the screws.
|
16.
|
If the window still falters, the rear of the rail can be raised 0.5 mm.
|
18.
|
Fit the trim and water cover. Clean the glass.
|