SAAB WIS ONLINE

Compressor high-pressure pipe (V6)

Compressor high-pressure pipe (V6)

To remove



1. Place the car on a lift.

2. Drain the refrigerant from the A/C system. See Draining and filling of refrigerant .

3. Detach the high-pressure hose from the compressor and plug the openings.

4. Raise the car.

5. Detach the pipe from the receiver and plug the openings.


6. Loosen the pipe from the holder on the subframe and remove it.


To fit


Note

Insert the high-pressure pipe in the engine bay from the left side.



1. Position the high-pressure pipe on the LH subframe.

2. Remove the plugs. Replace the O-ring on the receiver connection, lubricating it with synthetic vaseline.

3. Screw on the PAD connection to the receiver.

Tightening torque: 8 Nm (5.9 lbf ft)

4. Press in the high-pressure pipe to the holder on the subframe.

5. Remove the plugs. Replace the O-ring on the compressor connection, lubricating it with synthetic vaseline. Fit the bolts and pipes.

6. Adjust the oil level in the compressor. See Filling and adjustment of compressor oil .


Fit the compressor.

Tightening torque: 20 Nm (14.8 lbf ft)

7. Lower the car to the floor.

8. Evacuate the A/C system and refill with refrigerant. See Draining and filling of refrigerant .