Compressor low-pressure pipe (V6)
|
Compressor low-pressure pipe (V6)
|
The compressor's low-pressure pipe runs from the expansion valve via a joint to the compressor.
Important
|
Be careful not to contaminate the expansion valve.
|
|
1.
|
Place the car on a lift.
|
2.
|
Remove the right headlamp, direction indicator and grille.
|
3.
|
Drain the refrigerant from the A/C system, see
.
|
4.
|
Detach the inlet hose with mass air flow sensor without unplugging the contact and place it to one side.
|
5.
|
Detach the high-pressure pipe from the compressor and place it to one side.
Plug the openings.
|
6.
|
Detach the front end of the low-pressure pipe from the compressor.
Plug the openings.
|
7.
|
Detach the low-pressure pipe from the joint block on the right-hand structure by the service nipple.
|
8.
|
Remove the low-pressure pipe.
First, pull it down from the compressor under the car and then up.
Note
|
Make a note of how the pipe is positioned before removing it.
|
|
9.
|
Loosen and push aside the power-steering oil container.
|
10.
|
Detach the rear end of the low-pressure pipe from the expansion valve.
Plug the openings.
|
11.
|
Loosen the pipe from the holders on the structure.
|
12.
|
Carefully lift out the low-pressure pipe.
|
1.
|
Position the rear end of the low-pressure pipe in its correct location.
Adjust the oil volume in the compressor, see
.
|
2.
|
Remove the plugs and lubricate the O-rings on the low-pressure pipe.
|
3.
|
Connect the low-pressure pipe to the expansion valve.
|
4.
|
Fit the power-steering oil container.
|
5.
|
Fasten the pipe with the holders on the structure.
|
6.
|
Position the front end of the low-pressure pipe.
Note
|
Start by lowering the pipe from the structure out into the right-hand wing in front of the air filter, into the engine bay and up to the compressor above and behind existing pipes to the power steering inlet.
|
|
7.
|
Remove the plugs and lubricate the O-rings on the pipes to the compressor.
|
8.
|
Mount the O-ring on the connection towards the joint block, lubricate with synthetic vaseline.
|
9.
|
Press together the joint block and tighten.
Tightening torque: 8 Nm (5.9 lbf ft)
|
10.
|
Remove the plugs and lubricate the O-rings on the low-pressure pipe.
Note
|
Check that the low-pressure pipe is positioned correctly.
|
|
11.
|
Push the low-pressure pipe into the compressor and tighten it.
Tightening torque: 20 Nm (14.8 lbf ft)
|
12.
|
Fit an O-ring on the high-pressure pipe and lubricate with synthetic vaseline. Tighten down the high-pressure pipe.
Tightening torque: 20 Nm (14.8 lbf ft)
|
13.
|
Vacuum pump the A/C system and refill with refrigerant, see
.
|
14.
|
Connect the inlet hose to the mass air flow sensor.
|
15.
|
Fit the right headlamp, direction indicator and grille.
|