Receiver
Receiver |
1. |
Place the car on a lift.
|
2. |
Drain the refrigerant from the A/C system, see
.
|
3. |
Remove the grille and left headlamp as well as direction indicator.
|
4. |
Remove the front covering below the radiator unit.
|
5. |
Detach the A/C pipe connections from the receiver.
Plug the openings. |
6. |
Loosen the receiver and holder from the left-hand side of the condenser.
Plug the condenser. |
7. |
Lower the receiver under the car.
|
To fit |
1. |
Adjust the oil volume in the compressor, see
.
Lift up the receiver and holder to the condenser. |
2. |
Adjust the position of the receiver so that the PAD connections are parallel.
|
3. |
Lubricate the O-ring and fit the receiver.
|
4. |
Remove the plugs and lubricate the O-rings on the receiver pipes.
|
5. |
Screw on the A/C pipe connections to the receiver.
Tightening torque: 8 Nm (5.9 lbf ft) |
6. |
Fit the front covering below the radiator unit.
|
7. |
Vacuum pump the A/C system and fill with R134a refrigerant, see
.
|
8. |
Fit the left headlamp, direction indicator and grille.
|