Throttle pedal cable/adjustment of throttle pedal cable, V6
Throttle pedal cable/adjustment of throttle pedal cable, V6 |
To remove |
1. |
Open the data link connector cover.
|
2. |
Undo the screws in the data link connector.
|
3. |
Remove the screws and clip securing the lower panel with air duct.
|
4. |
Unplug the connector for the floor lighting.
|
5. |
Lift out the lower panel.
|
6. |
Disconnect the throttle cable from the throttle pedal by sliding back the bush and removing it and the cable.
|
7. |
Remove the upper engine cover.
|
8. |
Withdraw the cable and its sheathing through the rubber bush in the bulkhead.
|
9. |
Disconnect the throttle cable from the throttle body.
|
10. |
Undo the clip and withdraw the throttle cable sheathing.
|
To fit |
Note | ||
Spray the connector with Kontakt 61, part no. 30 04 520, before plugging in. |
1. |
Grease the rubber bush in the bulkhead with acid-free petroleum jelly (vaseline) and push the cable and its sheathing through the hole in the bush from the engine bay side.
|
2. |
Pull the cable through the bulkhead and into the cabin.
|
3. |
Hook the cable onto the throttle body in the engine bay. Fit the clip.
|
4. |
Attach the wire to the accelerator pedal.
|
6. |
Fit the connector to the floor lighting.
|
7. |
Fit the data link connector retaining screws and tighten them.
|
8. |
Fit the lower panel.
|
9. |
Close the data link connector cover.
|