Crankshaft position sensor
Crankshaft position sensor |
|
To remove |
1. |
Remove the engine cover.
|
2. |
Undo and separate the connector.
|
3. |
Loosen the securing points on the cable.
|
4. |
Raise the car.
|
5. |
Loosen the upper bolt on the turbo bracket and the position sensor heat shield, remove the shield.
|
6. |
Remove the sensor and O-ring.
|
To fit |
1. |
Fit the sensor with a new O-ring and apply engine oil.
|
2. |
Fit the sensor heat shield and bracket.
|
3. |
Insert and secure the cable. Be careful not to let the cable jam or become damaged.
|
4. |
Lower the car to the floor.
|
5. |
Secure the cable, spray the connector with Kontakt 61 (part no. 30 04 520), plug in the connectors and fit the holder.
|
6. |
Start the engine and check for any leaks. Fit the engine cover.
Tightening torque 50 Nm (36 lbf ft) |