Ignition discharge module, rear
|
Ignition discharge module, rear
|
1.
|
Remove the engine cover.
|
2.
|
Undo the screws to the heat shield.
|
3.
|
Unplug the connector to the pressure sensor on the intake manifold.
|
4.
|
Remove the ignition discharge module.
|
5.
|
Unplug the ignition discharge module connector.
|
1.
|
Coat the rubber seals with Krytox (part No. 30 19 312).
|
2.
|
Spray the connectors with Kontakt 61 (part no. 30 04 520). Plug the connectors into the ignition discharge module.
|
3.
|
Fit the ignition discharge module.
Tightening torque: 8 Nm (6 lbf ft).
|
4.
|
Plug in the connector to the pressure sensor on the intake manifold.
|
5.
|
Screw on the heat shield.
|