SAAB WIS ONLINE

Speed, bus from TC/ABS

Speed, bus from TC/ABS


The TC/ABS control module sends a bus message "Wheel speed, right front, XXX km/h” via the P-bus to the Trionic control module connection 19 and 66. This speed signal is used to:


• prevent adaptation of idle speed control when the car is moving.

• on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.

• activate speed limitation by limiting the maximum air mass/combustion at 240 km/h.





Diagnostics


• If there is no speed signal, diagnostic trouble code P0502 will be generated.

• If the speed value is implausible, diagnostic trouble code P0501 will be generated.


System reaction to a fault


• The speed (bus from MIU) is used as a substitute value.

• Cruise control is blocked.