SAAB WIS ONLINE

EVAP pressure sensor

EVAP pressure sensor

Warning

Removal of the tank pressure sensor involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

Work only in a well-ventilated area! If approved equipment for the extraction of fuel vapour is available, be sure to use it.

Wear suitable gloves! Prolonged contact with fuel can cause skin irritation or dermatitis.

Keep a class BE fire extinguisher near at hand! Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.

No smoking anywhere in the vicinity,

Wear protective goggles.


To remove


1. Remove the fuel tank, see Evaporative emission system (ORVR), adjustment, replacement, Fuel tank .

2. Clean around the pressure sensor with compressed air.


3. Undo the screw on the pressure sensor.

4. Carefully remove the pressure sensor.


To fit



1. Make sure the sealing surfaces are clean.

2. Apply acid-free Vaseline or equivalent to the O-ring.

3. Fit the pressure sensor.

4. Tighten the screw.

5. Fit the fuel tank, see Evaporative emission system (ORVR), adjustment, replacement, Fuel tank .