P1260
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE.
Throttle Return Spring. Too Low Force. NOTE. May set if Mechanism is not Reseted.
Fault symptoms
On-Board Diagnostics
Type of diagnosis:
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
-
|
Ignition in ON position.
|
Fault criteria:
-
|
Throttle motor receiving close to 0 % PWM in opening direction for 4 seconds.
|
Dependents:
System reaction to a fault:
OK report:
-
|
Accelerator pedal has been depressed at some time and then fully released. 120 s has expired since then without fault criteria being fulfilled.
|
Fault handling:
(See section
Fault handling III, other emission-related components and functions
for more information.)
Diagnostic help
Throttle return spring is too weak.
Check the wiring
Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this.