SAAB WIS ONLINE

P1306

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE. Running unevenly and misfiring.

P1306


Cylinder 6 Misfire Detected. Catalyst Damaging.



Fault symptoms


CHECK ENGINE.

Running unevenly and misfiring.


On-Board Diagnostics

Type of diagnosis:


- Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.


Enable criteria:


- General conditions for this trouble code: Atmospheric pressure must exceed 78 kPa and the engine coolant and intake air temperatures must exceed -7°C.

- Engine running. Main relay voltage exceeding 10V. Ignition discharge module combustion signals registering. The number of missing combustion signals is accumulated for each cylinder every 200 engine revolutions. The total number of accepted misfires during 200 engine revolutions is specified in a load and engine speed-dependent matrix.


Fault criteria:


- Number of missing combustions exceeding number of accepted misfires.


Dependents:


- P1313 and P1324.


System reaction to a fault:


- Under high engine loads, closed loop will be blocked while misfiring occurs.


OK report:


- Provided the fault criteria are not fulfilled during the driving cycle the OK report occurs at ignition off before the engine stalls. Two types of OK reports can be given: Type 1: If a DTC is already stored for the diagnosis and similar operating conditions have occurred (coolant temperature above or below 71°C, engine speed 375 rpm and load 10%). Type 2: If there is no DTC stored for the diagnosis or similar operating conditions have not occurred.


Fault handling: (See section Fault handling I, catalytic converter harmful misfiring for more information.)


- Type I.


Diagnostic help

If any other trouble codes have been generated, check whether fault diagnosis should be started on any of them first. Read Freeze Frame and change spark plugs.

Then check the compression, ignition and injector for the relevant cylinder. The car is driven so that the catalytic diagnosis can be carried out. If necessary the catalytic converter is changed.

Functions in the diagnostic tool related to the fault:


Diagnostic status for the diagnosis.

Misfire counter for the relevant cylinder.

Activation of misfire counter resetting.

Activating ignition trigger for relevant cylinder.

Activating injector test for relevant cylinder.


See also description on activating under "Activate" menu for more information.