SAAB WIS ONLINE

Headlamps (from VIN Y3008926)

Headlamps (from VIN Y3008926)

To remove


1. Remove the grille.


2. Undo the direction indicator screw, unplug the connector and remove the direction indicator.

3. Remove the three screws holding the headlamp.


4. Pull out the headlamp so that the lower plastic clip opens.

5. Lift out the headlamp slightly so that the headlamp connector can be unplugged.

6. Lift out the headlamp.


To fit


1. Position the headlamp drain hoses so that these point downward.

Important

Make sure the headlamp drain hose is not pinched. The hose must not be kinked.



2. Position the headlamp correctly. Press it into the lower plastic clip.


3. Fit the three screws holding the headlamp.

4. Spray with “Kontakt 61” and plug the connectors to the lamp.

5. Fit the direction indicator, see


6. Fit the grille.

7. Adjust the headlamp, see .


Replacement of lamp bulb


Note

Fit bulbs with correct rating only, the wiring can otherwise be damaged.



1. Remove the cover on the back of the headlamp.

2. Unplug the connector to the halogen bulb.

3. Unhook the mounting bracket holding the halogen bulb and change the bulb.


Programming, headlamps


The DICE control module can be programmed for three different types of headlamp logic:

Important

Switching between main and dipped beams is only possible with the light switch in position 2. Applies to all alternatives.

The fuse 35 has been removed from cars on markets where daylight driving lights are not used. Program alternatives 1 and 2.

While the engine is being started, the dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but for safety reasons it is maximized to 20 seconds.


Alternative 1

When the light switch (10) is in position 0 or 1, none of the main lighting should be active.

In position 0, none of the position lights should be active. (Germany + other markets).

Alternative 2

When the light switch is in position 0, dipped beams should be on (daylight driving lights).

In position 0 it is not possible to switch between main and dipped beams (Sweden).

Alternative 3

When the light switch is in position 0 or 1, the dipped beams should be on.

In position 0 or 1 it is not possible to switch between main and dipped beams (Canada).

Programming, parking lights

Acoustic warning (yes/no)

Pre-programmed: yes