Headlamps (up to VIN Y3008925)
|
|
Headlamps (up to VIN Y3008925)
|
|
2.
|
Undo the direction indicator screw, unplug the connector and remove the direction indicator.
|
|
3.
|
Remove the three screws holding the headlamp.
|
|
4.
|
Pull out the headlamp so that the lower plastic clip opens.
|
|
5.
|
Lift out the headlamp slightly so that the headlamp connector can be unplugged.
|
|
6.
|
Lift out the headlamp.
|
|
1.
|
Position the headlamp correctly. Press it into the lower plastic clip.
|
|
2.
|
Fit the three screws holding the headlamp.
|
|
3.
|
Spray with “Kontakt 61” and plug the connectors to the lamp.
|
|
4.
|
Fit the direction indicator, see
|
|
6.
|
Adjust the headlamp, see
.
|
|
Note
|
|
Fit bulbs with correct rating only, the wiring can otherwise be damaged.
|
|
1.
|
Remove the cover on the back of the headlamp.
|
|
2.
|
Unplug the connector to the halogen bulb.
|
|
3.
|
Unhook the mounting bracket holding the halogen bulb and change the bulb.
|
The DICE control module can be programmed for three different types of headlamp logic:
|
Important
|
|
Switching between main and dipped beams is only possible with the light switch in position 2. Applies to all alternatives.
|
|
The fuse 35 has been removed from cars on markets where daylight driving lights are not used. Program alternatives 1 and 2.
|
|
While the engine is being started, the dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but for safety reasons it is maximized to 20 seconds.
|
|
|
Alternative 1
When the light switch (10) is in position 0 or 1, none of the main lighting should be active.
In position 0, none of the position lights should be active. (Germany + other markets).
Alternative 2
When the light switch is in position 0, dipped beams should be on (daylight driving lights).
In position 0 it is not possible to switch between main and dipped beams (Sweden).
Alternative 3
When the light switch is in position 0 or 1, the dipped beams should be on.
In position 0 or 1 it is not possible to switch between main and dipped beams (Canada).
|
Programming, parking lights
|
Acoustic warning (yes/no)
Pre-programmed: yes
