Selector lever housing
| Selector lever housing |
| To remove |
| 1. |
Remove the centre and floor consoles, see
Centre console
Remove the air duct to the rear air vent. |
|
| 2. |
Remove the circlip and the anti-rattle clip.
|
|
| 3. |
Drive out the pin while removing the end of the cable from the ball.
|
|
| 4. |
Remove the screws securing the selector lever housing.
|
|
| 5. |
Unplug the selector lever housing's connector.
|
|
| 6. |
Lift up the selector lever housing, undo the cable ties securing the wiring harness to the ignition switch and airbag, and unplug the electrical connection to the ignition switch.
|
|
| 7. |
Remove the clamp located beside the locking catches.
|
|
| 8. |
Carefully press the catches securing the cable ferrule towards each other and remove the cable from the bracket.
|
|
| 9. |
Lift out the selector lever housing.
|
|
| Fitting |
| 1. |
Fit the selector lever housing in place.
|
|
| 2. |
Connect the cable to the selector lever housing and fit the clamp.
|
|
| 3. |
Plug in the electrical connection to the ignition switch while putting the selector lever housing in place.
|
|
| 4. |
Refit the 2 cable ties for the wiring harness.
|
|
| 5. |
Push in the pin at the same time as the ball enters the end of the cable. Grip the end of the cable.
|
|
| 6. |
Fit the circlip and the anti-rattle clip.
|
|
| 7. |
Connect the air duct and tighten the selector lever housing.
|
|
| 8. |
Fit the centre and floor console, see group 8 Body, climate system, Interior equipment.
|
|
| 9. |
Adjust the position of the cable.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
